Dirty flame sensors
A furnace that lights and shuts off within seconds usually has a flame sensor coated with residue. It is a common first-cold-night call in Union City.

Furnace Repair | Obion and Lake counties
No heat around Union City or Reelfoot Lake on a cold night? Call to get connected with an independent provider who repairs gas, propane and electric furnaces in Obion and Lake counties.
Enter your ZIP code on the call to find a nearby technician.
Winter wind crosses the open farmland and the lake with little to slow it down, so homes around Tiptonville, Ridgely and Samburg can lose heat quickly on a January night. A furnace that has idled through a mild December may then be asked to run for hours.
Fuel varies across the region. Union City has natural gas service in many neighborhoods, while rural homes around Hornbeak and Rives often rely on propane or electric furnaces.
See the Union City and the Northwest page for notes on each place.
Local angle
Most no-heat calls here come down to a handful of parts and conditions.
A furnace that lights and shuts off within seconds usually has a flame sensor coated with residue. It is a common first-cold-night call in Union City.
In rural homes, an empty or low tank, or a regulator issue after a refill, can stop a propane furnace. The tank gauge is the first thing to check.
Hot surface ignitors are fragile and wear out. A furnace that clicks and tries but never lights may need a new one.
Dusty farm air and pets can clog filters quickly, tripping the high-limit switch so the burners shut down.
Cabins around Reelfoot Lake that sit empty in winter need extra care. If you are heating a closed-up place for a weekend visit, check the filter and make sure nothing is stored against the furnace or blocking the return.
Older homes in Union City may have furnaces that have run for many winters. If a technician mentions the heat exchanger, ask for the finding in writing and for both repair and replacement options.
Keep a working carbon monoxide alarm near the bedrooms, especially in homes with gas or propane heat.
Check the tank gauge and make sure the furnace switch and breaker are on. If the tank ran out, call your propane supplier first, since the system may need a leak check before the furnace is relit.
A dirty flame sensor is the most common cause, followed by a failing pressure switch or overheating from a dirty filter. Note any flashing code on the control board and share it on the call.
Have the furnace inspected before relying on it, and keep a carbon monoxide alarm working. A technician can check the burners, venting and heat exchanger.

Next step
Describe what the system is doing and get connected with an independent provider who serves the area.
Enter your ZIP code on the call to find a nearby technician.