Capacitors and contactors
Year-round use wears these parts in both summer and winter, and they are among the most frequent repairs.

Heat Pump Repair | Weakley County
Heat pump problems in Martin, Dresden and the Weakley County farm towns. Call to get connected with an independent provider who repairs heat pumps in the county.
Enter your ZIP code on the call to find a nearby technician.
Heat pumps are a common choice in Weakley County, from newer homes in Martin to manufactured homes and farmhouses around Palmersville and Sharon. They heat and cool with one outdoor unit, so a problem can affect comfort in any season.
Rental homes near campus often have heat pumps that run all year with heavy use, which wears out fan motors, capacitors and defrost parts faster.
See the Martin and Weakley County page for notes on each place.
Local angle
Rural exposure and heavy use in rentals account for many of the calls here.
Year-round use wears these parts in both summer and winter, and they are among the most frequent repairs.
Packaged heat pumps on manufactured homes can suffer from crushed ducts under the floor and loose connections at the unit.
Harvest dust and debris clog outdoor coils, reducing both cooling in summer and heating in winter.
Thermostats replaced or reset between tenants can be set up incorrectly for a heat pump.
Small leaks reduce winter heating noticeably, since a heat pump needs a full charge to pull heat from cold air.
Homes around Sharon and Gleason sit on open ground where winter wind strips heat from the outdoor coil. That is normal, but it makes a weak defrost control or a tired fan motor show up sooner.
Owners of rental homes can call about heat pump repair at a property they own. Ask the tenant what the thermostat shows and whether the outdoor unit runs.
For manufactured homes, mention whether the system is a packaged unit beside the home or a split system, and whether the ducts under the floor have been damaged.
Clear grass and debris from around the outdoor unit, especially after harvest.
Older homes in Dresden that moved from a furnace to a heat pump may still have the original duct sizes. If some rooms feel cool even when the system runs, mention it, since airflow may be part of the answer.
Check the thermostat setting, the breaker and the filter. Look for ice on the outdoor unit and listen for the fan. Then call and describe what you found.
Heavy use and frequent thermostat changes can wear parts faster. A tune-up before summer and winter helps catch worn capacitors and dirty coils.
Heat pump air feels cooler than furnace air. Air that feels cold may mean a defrost cycle, a stuck reversing valve or low refrigerant. A technician can test each.
Keep exploring

Next step
Describe what the system is doing and get connected with an independent provider who serves the area.
Enter your ZIP code on the call to find a nearby technician.